![]() > Try BootMii if Priiloader is not working for you. ![]() Now you no longer need a Wiimote to start booting up your ISO files, as a GC controller (d-pad) can navigate the Homebrew Channel.Īpparently you can have it boot straight to a Homebrew app if you want, but I've never done this. Then turn on Wii normally and it should now boot straight to the Homebrew Channel. hold those buttons until a white Priioader menu appears.ĩ) Go to the "Settings" menu at the bottom.ġ0) At the top, change "Autoboot" to "Homebrew Channel"ġ2) Hold Power Button to turn off Wii. Press A on GC controller (or whatever it says for Wiimote) to start the install.ħ) When it is done, exit back to the Homebrew Channel and then hold the power button on your Wii to turn it off.Ĩ) Turn Wii back on by holding the Power Button & the Reset Button, right below the power button, at the same time. Older versions of the game are not compatible with the exploit.1) Have your Wii hacked so that the Homebrew Channel is available.Ĥ) From the downloaded and unzipped files, Copy the "priiloader" folder, which is inside the "apps" folder, and paste it into the "apps" folder that should be on the root of your SD card.ĥ)Insert SD Card into Wii -> Boot up Wii -> go to Homebrew Channel -> load Priiloader.Ħ) Wait a second as it sets up some files. If already own Brain Age or Brain Training and have had it installed on your Wii U for a while, try deleting it and redownloading the game from the eShop. Pokemon Mystery Dungeon: Explorers of the SkyĬurrently, Brain Age is the cheapest of these titles on the eShop ($6.99 USD).Kirby: Squeak Squad / Kirby: Mouse Attack.The following DS Virtual Console games are compatible: If you want to use the DS Virtual Console method, you should purchase the game before proceeding to the next section. You cannot install this DS Virtual Console game to a USB drive. The DS Virtual Console game must be a legitimately purchased copy of the game installed to the internal memory of your device. The second method is to purchase a very cheap exploitable DS Virtual Console game to launch your Custom Firmware automatically at boot. Unfortunately, the nature of this exploit is that this must be run after every reboot. The first method is to run a browser exploit through the browser which will patch the system. There are two methods for using Wii U custom firmware. Copy config.ini to the /wiiu/apps/mocha/ folder on your SD card.Copy the contents of the Wii U NAND Dumper.Copy the contents of the WUP Installer GX2. ![]() zip to the /wiiu/apps/ folder on your SD card
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |